987幸运飞艇

Home / News / Start-up Sequence of Raymond Mill

News

Start-up Sequence of Raymond Mill2019-03-24

How to start a Raymond Mill?

start the bucket elevator;


Start pulse dust collector;


Start jaw crusher;


After the material is stored in the silo, start the analysis machine;


Start the air blower (starting with empty match and loading after normal operation);


Start the host, and then immediately start the electromagnetic feeder at the moment of starting the host. The grinding work is now started.


The simple table of the operation sequence of Raymond mill987幸运飞艇 is as follows: ‘Start’, hoist-crusher-analyzer-fan-host-feeder.


When Raymond mill stops:


1. Close the feeder first and stop feeding;


2. Stop the host after about one minute;


3. Stop the blower after blowing the remaining powder;


4. Finally close the analyzer.


987幸运飞艇 The shutdown sequence is: feeder-host-blower-analyzer.


note:


Before starting the Raymond mill987幸运飞艇, check whether all inspection doors are closed tightly, whether there are iron blocks, sundries, and adjust the direction of the fan and the host of the Raymond mill to see if they reverse. The air valve should be in the fully open position. Check whether the screws and nuts are loose. The belt of the host must not be too tight or too loose.

 

Raymond mill

 

 

 

 

 

Pre:Coal Pulverizer, Raymond Roller Mill
Next:Back
助赢幸运飞艇软件 pk10微信群或者飞艇群 天天幸运飞艇计划软件 免费幸运飞艇计划手机 幸运飞艇助赢软件 幸运飞艇pk10开奖时间 全天幸运飞艇精准计划 北京pk10幸运飞艇直播 北京幸运飞艇开奖直播 幸运飞艇 开奖b678甸vip 幸运飞艇【上恒达集团~HD161。COM~平台】 幸运飞艇【上恒达集团~HD161。COM~平台】 幸运飞艇【上恒达集团~HD161。COM~平台】 澳门百家乐【上恒达集团~HD161。COM~平台】 澳门百家乐【上恒达集团~HD161。COM~平台】 澳门百家乐【上恒达集团~HD161。COM~平台】 六合彩公司【上恒达集团~HD161。COM~平台】